If your first layer isn’t sticking, your nozzle is either too high, your bed is dirty, or your settings are off. Fixing first layer adhesion comes down to proper Z offset, a clean surface, and slower first layer settings. If you don’t fix this, nothing else matters—every print starts with the first layer. This post […]
3D printer setup
How to Set Z Offset on a 3D Printer (Perfect First Layer Every Time)
Z offset controls how close your nozzle is to the bed, and getting it right is the difference between prints sticking or failing. To set Z offset correctly, lower the nozzle until filament is slightly squished—not round and not smeared. If your first layer fails, this is almost always the root cause. This post contains […]
Why PLA Won’t Stick to the Bed (And How to Fix It Fast)
PLA won’t stick to the bed when your first layer isn’t properly squished, or the surface isn’t prepared correctly. To fix PLA not sticking fast, adjust your Z offset, clean your build plate, and dial in your first layer settings. If your print peels up, slides around, or never sticks in the first place—you’re dealing […]
Do You Need an Uninterruptible Power Supply for 3D Printing?
A random power blip can turn a long print into plastic trash fast. That is why a lot of makers ask the same question: do you need an uninterruptible power supply (UPS) for 3D printing? The honest answer is sometimes. If your printer has a solid power loss recovery feature, you may survive short outages […]
Easily Calibrate Your 3D Printer’s Z Offset (Ender 3)
When beginning your 3d printing journey it probably feels like a million things could go wrong. Is my bed level, is it too cold, is my filament wet? And the list goes on… Maybe, you need to calibrate your Z offset. Maybe, you aren’t even sure what the heck I’m talking about. Either way, stick […]